Go to the fuel filter area, and look for a shorted wire, seeing as the problem happened while poking around there. When you say you have fuel, do you...
I was using my truck yesterday with no problem. I went poking around by the fuel filter looking for a fuel leak (didn’t find source). A while later I...
Oh, that was unfortunate, it is necessary to buy quality sometimes, but with a lot of purchases, I have had success with the cheap brands. I look for...
While I was getting the air out, I noticed something looked "off". I tugged on the wires and it turns out the glow plug controller relay is broken. I...
On the drivers side of the engine, at the front, are two injectors that are easily accessible, they have small steel tubes running to them, I loosen...
First look at my last post, it has been edited. Sitting for so long likely means the fuel has drained back to the tank. Loosen 2 injector nuts, make...
Well unfortunately brand new PMD and harness didn't help. The truck cranks but will not start. it had been running fine but it has been sitting for 2...
Just the plug will work. The ground was mounted from the plug, to a PMD retaining screw on mine, so when I removed the PMD, I connected the ground to...
Thanks Grancito. years ago, I relocated the PMD and heat sink to the bumper hole (I will move it if I need to). I do seem to need a new pmd every 2-4...
My truck won't start all of a sudden after running great for the past few years. In the past, it has always needed just a new PMD and 6 foot harness....