SSDieselSupply.com
SSDPro-Exhaust.com

Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Groups Groups
  • grancito's Avatar
    04-25-2020, 03:50 PM
    grancito replied to a thread Pulling engine in Engine
    The pan doesn't have to be removed to replace the seals, but I had to remove the engine from the stand to fit the rear seal. Puncture the seal with a...
    9 replies | 727 view(s)
  • CAdiesel's Avatar
    04-25-2020, 01:17 AM
    CAdiesel replied to a thread Pulling engine in Engine
    Oil pressure was very good prior to pulling motor. So I think I’ll leave it. Motor is in a stand so I was planning on flipping it and redoing the...
    9 replies | 727 view(s)
  • grancito's Avatar
    04-24-2020, 04:29 PM
    grancito replied to a thread Pulling engine in Engine
    I don't know the life span of the pump, but if the oil pressure was OK at hot idle, it is probably fine. I had to put a new later model high capacity...
    9 replies | 727 view(s)
  • CAdiesel's Avatar
    04-24-2020, 01:03 PM
    CAdiesel replied to a thread Pulling engine in Engine
    Thanks Grant. Looks like I’m doing exhaust valves. I’m considering doing the oil pump while I have the engine out. Do you have any idea what kind...
    9 replies | 727 view(s)
  • grancito's Avatar
    04-22-2020, 03:11 PM
    grancito replied to a thread Pulling engine in Engine
    Only just spotted your post, and have been looking each day. The exhaust valves look bad, the original valves don't have the case hardening on the...
    9 replies | 727 view(s)
  • CAdiesel's Avatar
    04-20-2020, 04:48 PM
    CAdiesel replied to a thread Pulling engine in Engine
    Short of just looking polished, the rockers and pushrods look fine. I’m going to try to attach a photo of what the valve stems look like. The exhaust...
    9 replies | 727 view(s)
  • grancito's Avatar
    04-18-2020, 06:34 PM
    grancito replied to a thread Pulling engine in Engine
    The chipped valve tips could chew the rocker surface, I could send you a set of exhaust valves that are only slightly hammered on the tips of a few,...
    9 replies | 727 view(s)
  • CAdiesel's Avatar
    04-18-2020, 11:52 AM
    CAdiesel replied to a thread Pulling engine in Engine
    Thanks, Grant. I now have the motor out and the heads off and I’m at a point where I need to decide if it’s even worth putting the motor back...
    9 replies | 727 view(s)
  • grancito's Avatar
    04-10-2020, 06:24 PM
    grancito replied to a thread Pulling engine in Engine
    I took mine out of the same year suburban, used one method to get the top 2 bolts then accessed them from the top when installing. For removal, I...
    9 replies | 727 view(s)
  • CAdiesel's Avatar
    04-09-2020, 06:11 PM
    CAdiesel started a thread Pulling engine in Engine
    first time pulling an engine, the kids are helping me while quarantined and auto shop is on hold while I try to figure out how to remove the top two...
    9 replies | 727 view(s)
No More Results