problems with a remam 6.5

[454ss]

Can anyone help? I got a 1995 yukon with a 6.5 in it. A year and a half ago i had a remam put in and it ran good for a month, Then it bent a push rod and nothing else. Well it sat for all this time and 2 weeks ago I got it running again. Ran good for those two weeks. Then today I took my daughter to school and when i got back home it showed codes 29 33 34. Would a bad vacum pump show all these codes or just code 29? Could sitting all this time have ereased the timming settings in the computer? The motor still runs but is louder.

[Chevylover]

DTC 29 - Glow Plug Relay Fault

DTC 33 - EGR Control Pressure/Baro Sensor Circuit High

DTC 34 - Injection Timing Stepper Motor Fault


First to check all grounds and battery cables, than to check the PMD. Where is it located ? Still on the IP ? How old is it ? New with reman engine or still the old one ?

Cu,
Sven

[grancito]

The 29 is a red herring, I got that from a turbo boost problem.