Last tips/hints/tricks before installation of plugs and injectors?

[christja]

Ive got my instant heat glow plugs and marine injectors in now and i was wondering if those of you that have installed them before have any last hints or tricks for me that would make it easier?

Thanks:)

[sixnickel]

The left side is a no bainer. The right side is the fun one! Don't fool around get the tubro off and out of the way. Change the rear glow plug while the rear injector is out, do it from the top. Do the 3 front glow plugs through the wheel well with the tire off. Get the rubber skirt off out of your way also.Number 3 plug I pull the heat sheild tube off. To go back together a add about 4" wire to it, put the wire through the tube, put the wire on the plug then put the tube back on. Make shure the wire connectors go back on snug if not change them. Go easy on the injector lines move them to the side enough to get the 30mm or 1 3/16 thin wall deep socket on. The book says 44 '#s torque on the injectors. Also keep every thing cleen. Good Luck and Have Fun!!