njdevi11
07-21-2007, 12:33 AM
After I finished installing my clutch line. I took the CJ out for a little test drive. I drove around the block a few times and everything was going great. Then I stopped, put it in granny low and whomped on it, then let off, the inertia of the truck took the engine with it for a few seconds then the engine died and wouldn't restart.
I believe I might have let the tank go empty and ran it dry. The tank sounded pretty empty when I hit it with a wrench. I plan on filling it up tomorrow and re-priming the fuel system. Is there anything else I might want to check? the timing? could the timing chain break? I didn't look into it but just wanted to see if anybody had any ideas.
I believe I might have let the tank go empty and ran it dry. The tank sounded pretty empty when I hit it with a wrench. I plan on filling it up tomorrow and re-priming the fuel system. Is there anything else I might want to check? the timing? could the timing chain break? I didn't look into it but just wanted to see if anybody had any ideas.