jumpy gas needle

[grvrjr]

My gas needle started jumping around right after I changed my valve gaskets. In this process I had to remove the upper & lower intake manifold which invoved me removing the ground that was connected to the lower intake manifold bolt on the passenger side of the manifold. Right after I finished with the repair the needle started jumping so I moved the ground to the fuel filter mount and it still jumps. Any solutions?

[MAGNUM SERVICES]

Sounds to me like it is still not grounding right.

[grancito]

That is your engine ground, not associated with body grounds where the fuel gage system grounds. You moved something like a connector, or just coincidence.

[dano6.5]

Hope your fixed. If not, my exhaust gasket blew a hole. The hot exhaust melted the wire harness that runs down the fire wall to the drivers side chassic. Melting the wires for the tail lights, fuel gauge etc.