SSDieselSupply.com
SSDPro-Exhaust.com
  • grancito's Avatar
    04-25-2020, 03:50 PM
    grancito replied to a thread Pulling engine in Engine
    The pan doesn't have to be removed to replace the seals, but I had to remove the engine from the stand to fit the rear seal. Puncture the seal with a...
    9 replies | 703 view(s)
  • grancito's Avatar
    04-24-2020, 04:29 PM
    grancito replied to a thread Pulling engine in Engine
    I don't know the life span of the pump, but if the oil pressure was OK at hot idle, it is probably fine. I had to put a new later model high capacity...
    9 replies | 703 view(s)
  • grancito's Avatar
    04-22-2020, 03:11 PM
    grancito replied to a thread Pulling engine in Engine
    Only just spotted your post, and have been looking each day. The exhaust valves look bad, the original valves don't have the case hardening on the...
    9 replies | 703 view(s)
  • grancito's Avatar
    04-18-2020, 06:34 PM
    grancito replied to a thread Pulling engine in Engine
    The chipped valve tips could chew the rocker surface, I could send you a set of exhaust valves that are only slightly hammered on the tips of a few,...
    9 replies | 703 view(s)
  • grancito's Avatar
    04-10-2020, 06:24 PM
    grancito replied to a thread Pulling engine in Engine
    I took mine out of the same year suburban, used one method to get the top 2 bolts then accessed them from the top when installing. For removal, I...
    9 replies | 703 view(s)
No More Results
About kustomizer

Basic Information

About kustomizer
Biography:
none
Location:
ky
Interests:
racing
Occupation:
driver
Year:
1994
Make:
chevy
Model:
3500
Mileage:
150,000-249,999
Modifications:
none
Other Trucks:
none

Statistics


Total Posts
Total Posts
9
Posts Per Day
0.00
General Information
Last Activity
08-14-2012 07:46 PM
Join Date
07-08-2009
Referrals
0

1 Friend

  1. grancito grancito is offline

    Senior Member

    grancito
Showing Friends 1 to 1 of 1