SSDieselSupply.com
SSDPro-Exhaust.com

Search:

Type: Posts; User: Geoffrey

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    2,568

    solid axel swap

    my truck 2000 2500hd 6.5L f vin 2wd auto trans
    doner 1986 3500hd 6.2L 4wd standard trans

    So im thinking of doing a solid axel swap on my truck i would like to keep the auto trans for now so will...
  2. Replies
    4
    Views
    1,572

    your saying it not worth my time to swap over the...

    your saying it not worth my time to swap over the pump rather just get the ecm reflashed?
  3. Replies
    4
    Views
    1,572

    mechanical ip swap

    hi all,
    ive been looking for a way to get some more power out of the truck for a while and i think swaping over to a mechanical ip will allow me to increase the fuel flow more then messing with a...
  4. Thread: acc belt

    by Geoffrey
    Replies
    2
    Views
    816

    acc belt

    My vaccume pump recently went in my truck but the turbo wastegate is mechanicaly controlled (home made) so I was wondering if anyone had a part number for an acc belt with out a vaccume pump?

    I...
  5. Thread: more power

    by Geoffrey
    Replies
    6
    Views
    5,332

    could i up the signal voltage to a certin sensor...

    could i up the signal voltage to a certin sensor to allow it to put more fuel in? would changing the govener springs in the injection pump make a diffrence?
  6. Thread: more power

    by Geoffrey
    Replies
    6
    Views
    5,332

    2000 6.5 400xxx kms with a 4" exhaust from the...

    2000 6.5 400xxx kms with a 4" exhaust from the down pipe back to the front of the bed which goes to a 7" stack, the turbo is held open with a home made wastegase and the factory air cleaner was...
  7. Thread: more power

    by Geoffrey
    Replies
    6
    Views
    5,332

    more power

    i would like to get some more power out of the old girl, i have read up on ecm reflashes and proformence chips but is there any way to get more fuel flow with out the computer controlling it ie ramp...
  8. Thread: wastegate

    by Geoffrey
    Replies
    6
    Views
    2,993

    As soon as it hits 120 kph it just dropps off,...

    As soon as it hits 120 kph it just dropps off, but I haven't got a light for it. I did get a "low pressure boost sensor a" once but I cleared it and it never came back
  9. Thread: wastegate

    by Geoffrey
    Replies
    6
    Views
    2,993

    there isnt a rev limiter that i know of it will...

    there isnt a rev limiter that i know of it will keep pulling past 120 just there is no movement on the boost guage past 120.

    the truck is a 2000 with 390,000 kms on it. the injection pump and...
  10. Thread: wastegate

    by Geoffrey
    Replies
    6
    Views
    2,993

    wastegate

    Hi all,

    The turbo on my truck cuts out or limits pressure when the truck is going faster then 120 kph. This is something gm has wired into the computer. So my question is how can the waste gate...
  11. Replies
    5
    Views
    4,547

    vegie or frier oil for fuel

    Hi all,

    I was wondering if anyone has run or is running vegie oil as a fuel in there trucks? I would like to start running it to cut costs on my fuel bills. But I have been a little scared to try...
  12. Replies
    10
    Views
    7,438

    I tryed replacing the computer and testing the...

    I tryed replacing the computer and testing the injectors for shorts in the circuit but I got nothing still. Turns over but no fuel or spark

    Any ideas?

    Thanks again for the help
  13. Replies
    10
    Views
    7,438

    Ill try testing the injectors like you said and...

    Ill try testing the injectors like you said and see what happens, I also have a new ecu on order to plug In and see what happens.

    I like the way you think husker 6.5, I was thinking the same...
  14. Replies
    10
    Views
    7,438

    Tested the pick up coil and it was fine ...

    Tested the pick up coil and it was fine

    Thanks for the help guys
  15. Replies
    10
    Views
    7,438

    93 s10 no start

    hi guys,

    im working on a 93 chevy s10 2.8L v6 with a 5 spd standard 2 wheel drive.

    the motor turns over but doesn't fire up. there's a new ignition coil and ignition control modual in it. but...
  16. Replies
    7
    Views
    2,422

    Why gas instead of diesel? A guy at work said to...

    Why gas instead of diesel? A guy at work said to run the truck with atf for 5-10 min would this work as well?

    Will the problem keep coming up because it has higher mileage on it?

    Thanks again
  17. Replies
    7
    Views
    2,422

    Its a 2000 C2500 with 385xxx, it had the ip done...

    Its a 2000 C2500 with 385xxx, it had the ip done about 50xxx kms ago rebuilt the turbo about the same time. There are no engine codes on it and there is some blow by when the oil fill cap is off.
    ...
  18. Replies
    7
    Views
    2,422

    grease in the intake?

    I pulled the breather off the passenger side valve cover and noticed that there was a "grease" looking substance in the breather as well as all the lines leading to it, how ever there was none in the...
  19. Replies
    5
    Views
    1,853

    2000 gmc serria and its OBD2

    2000 gmc serria and its OBD2
  20. Replies
    5
    Views
    1,853

    it felt like the nose of the truck dropped, i...

    it felt like the nose of the truck dropped, i have no check engine or service throttle soon lights on it.

    i believe the rpm fell off, but ill see if it happens again to know for sure

    thanks...
  21. Replies
    5
    Views
    1,853

    jolting on the highway

    I was driving down the highway today doing about 110km/h with a motor in the bed ( no major weight) and the truck jolted forward. almost as if i hit the breaks really hard. but i didnt happen after...
  22. Replies
    3
    Views
    4,958

    let me know how it works out, i was thinking of...

    let me know how it works out, i was thinking of doing it myself
  23. Thread: fuel control

    by Geoffrey
    Replies
    2
    Views
    1,065

    fuel control

    Hi all,

    I was wondering how to get more fuel out into the motor?

    I have in the past used mechanical pumps and just turned a screw to get more fuel, I'm unsure how to do this on an electric...
  24. Replies
    7
    Views
    3,069

    make sure you ground the ground wire from the pmd...

    make sure you ground the ground wire from the pmd harness back to the ip, i got the same symptoms from mine
  25. Thread: hey all

    by Geoffrey
    Replies
    3
    Views
    1,033

    thanks for the help, its much appreciated

    thanks for the help, its much appreciated
Results 1 to 25 of 26
Page 1 of 2 1 2