SSDieselSupply.com
SSDPro-Exhaust.com

Search:

Type: Posts; User: grancito

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    2
    Views
    60

    I have a home made one 8 years old on the...

    I have a home made one 8 years old on the suburban and a bought 3 year old one on the 95 GMC . No problems. Only posible failure point would be water getting into the PCM connection. 94 has the good...
  2. Replies
    10
    Views
    299

    That scoring won't cause a problem, but if the...

    That scoring won't cause a problem, but if the other crank is better, you should use it. The engine out and in process is a pain, where are the easy 60's cars, I could have a 4 cylinder ford motor...
  3. Replies
    10
    Views
    299

    All looks good, I just put STD bearings in...

    All looks good, I just put STD bearings in recommended but you were lucky to find the .013 undersize. but mine is a bastard engine.
  4. Replies
    10
    Views
    299

    The bearings look good. There is a red light...

    The bearings look good. There is a red light shining on them that makes it look like the lead has gone in parts and the copper is showing. Check the "corrosion" area around the inlet valve at the top...
  5. Replies
    10
    Views
    299

    Cylinder 7 is the one that cracked in my engine,...

    Cylinder 7 is the one that cracked in my engine, it and 8 heat up the most. Any signs of bore scoring on 7? I would pull that piston to check for broken rings, and the state of the bearing will tell...
  6. Replies
    10
    Views
    299

    It sounds like it has recently been rebuilt....

    It sounds like it has recently been rebuilt. Check really well the heads and rear cylinders for cracks, then put it back together. Cracks kill these engines, I'm building a new one from a Brazilian...
  7. The mechanical waste gate control is good, but it...

    The mechanical waste gate control is good, but it drops my mpg by one mile, boost is too high at low throttle, 3 1/2 psi instead of 1 1/2 at 60 mph.
  8. Replies
    1
    Views
    155

    Second try to reply, Walt, the site has been...

    Second try to reply, Walt, the site has been mostly unavailable for weeks, and lost my post after I wrote it. Tach revs come from an alternator pulse, if the pulley has been changed to a different...
  9. My understanding is that the dielectric grease is...

    My understanding is that the dielectric grease is used instead of the pad.
  10. Replies
    4
    Views
    284

    If no ABS light, then it is likely that one of...

    If no ABS light, then it is likely that one of the two main rubber seals has ruptured in the master cylinder. This happened multiple times to my 82 Chev, new kit each time, then had no problem for...
  11. Thread: oil lines

    by grancito
    Replies
    4
    Views
    402

    I hear that your problem is common, and there are...

    I hear that your problem is common, and there are after market hoses. I have 3 of these trucks with no cooler lines problems, one with 25 years use. One is in rebuild, would like to know alternatives...
  12. Replies
    5
    Views
    355

    Good to have a simple fix.

    Good to have a simple fix.
  13. Replies
    5
    Views
    355

    A late reply, I have been away. Most likely worn...

    A late reply, I have been away. Most likely worn out brushes. The starter needs to be removed, easy to check the brushes. You could check the terminal from the solenoid to the starter while in place,...
  14. Replies
    2
    Views
    329

    Must be difficult to live in a cold place, it is...

    Must be difficult to live in a cold place, it is also difficult in a hot country, the AC in the 94 and 95 trucks is not adequate.
  15. Replies
    1
    Views
    297

    The additives are usually thin, and won't...

    The additives are usually thin, and won't lubricate or burn like diesel. I add about half a cup of additive to the diesel in the filter of the 6.2 Chev, when damp fuel has caused the pump to have a...
  16. Replies
    3
    Views
    361

    Good one, easy fix.

    Good one, easy fix.
  17. Replies
    5
    Views
    495

    The position of the connections makes it...

    The position of the connections makes it difficult to make them tight. It is best to put the cables on while the starter is not bolted in place.
  18. Replies
    3
    Views
    361

    Did you replace the switch, or just the lock...

    Did you replace the switch, or just the lock barrel? Check that the start wire to the starter is not touching the live wire.
  19. Replies
    5
    Views
    495

    That happens often to my old Chev when the...

    That happens often to my old Chev when the batteries are bad and it turns over slowly, it also happened when the solenoid contacts were burnt. The high current drawn by the starter, causes the...
  20. Replies
    3
    Views
    352

    That sounds like a nightmare, water pump...

    That sounds like a nightmare, water pump replacement is not easy.
  21. Replies
    3
    Views
    352

    Remove the wheel, then the inner guard, put a...

    Remove the wheel, then the inner guard, put a stand under the truck. The battery box stays behind. The guard is flexible, and a bit of maneuvering gets it out. I can see that mine are accessed by...
  22. Replies
    22
    Views
    4,380

    Very good, thanks for the feed back.

    Very good, thanks for the feed back.
  23. Replies
    24
    Views
    8,468

    Before you buy anything, check for gas out the...

    Before you buy anything, check for gas out the thermostat housing, then if there's gas one side, pull the head and look for cracks everywhere, especially the rear cylinder bore. That is where mine...
  24. Replies
    22
    Views
    4,380

    Yes, that is a hydroboost.

    Yes, that is a hydroboost.
  25. Replies
    22
    Views
    4,380

    Half an hour for you to change the parts, bleed...

    Half an hour for you to change the parts, bleed the master at the outlets of the master to not get air in the lines. Easy job.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4