SSDieselSupply.com
SSDPro-Exhaust.com

Search:

Type: Posts; User: ZiGBlazer

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    5,262

    Here are the pics

    Here are the pics
  2. Replies
    7
    Views
    5,262

    Just finished installing the Ignition Override...

    Just finished installing the Ignition Override with High Idle Mod. Push the button the RPMs jump up to 800 and you can take the key out and it still runs. Press Set on the cruise control RPMs jump up...
  3. I wonder what year and part # they are. The most...

    I wonder what year and part # they are. The most recent military TM I have shows a 2000 turbo 6.5 part # 12469163 with 205hp/440tq for the M1114.

    Has anyone seen a newer version of the TM...
  4. Replies
    3
    Views
    1,687

    You may have to bleed air out of a few of the...

    You may have to bleed air out of a few of the injector lines. It depends on how low on fuel you got. If it did then you have to crack the lines open just a little bit at the injectors an crank it...
  5. Thread: Seafoam

    by ZiGBlazer
    Replies
    3
    Views
    3,742

    Mine smoked a bit of gray for a while. I didn't...

    Mine smoked a bit of gray for a while. I didn't notice much difference in the 6.5L but I didn't expect to. It had new injectors, a newer injection pump, auxiliary fuel filter, and new fuel lines.
    ...
  6. Thread: Help!

    by ZiGBlazer
    Replies
    4
    Views
    1,873

    Sounds to me like a ground did not get hooked...

    Sounds to me like a ground did not get hooked back up properly. Make sure all the grounds got put back on, and didn't get pulled out from the fenders. Also check the ground strap at the back of the...
  7. Thread: ca.blues

    by ZiGBlazer
    Replies
    1
    Views
    1,188

    Check out SSDiesel.com if you haven't already. ...

    Check out SSDiesel.com if you haven't already.

    Otherwise I have had plenty of experience with the military 6.2/6.5s and they are usually in good condition. They are typically replaced at the...
  8. Thread: Seafoam

    by ZiGBlazer
    Replies
    3
    Views
    3,742

    I use Seafoam all the time. It works awesome in...

    I use Seafoam all the time. It works awesome in gas engines. I use it in all my small engines, every time I fill them up. Never had a fuel related problem with them. I use it in my gas vehicles...
  9. Replies
    2
    Views
    1,710

    I converted mine from DRW to SRW about 2 years...

    I converted mine from DRW to SRW about 2 years ago, and just converted it back before I sold it. Here are a couple pictures from SRW to DRW.

    To convert to SRW I got another set of tires and...
  10. Replies
    7
    Views
    5,262

    Just in case anyone was wondering, I now have a...

    Just in case anyone was wondering, I now have a baby Girl. Born Sunday August 22nd.

    I also just sold my '95 6.5L, which will be missed. But that means I can finally put a little money into my...
  11. Thread: No EGR.

    by ZiGBlazer
    Replies
    5
    Views
    3,316

    Yep, he can get you a chip to stop EGR functions....

    Yep, he can get you a chip to stop EGR functions. Just give him a call.
  12. Replies
    7
    Views
    5,262

    Thank you, I found it, just took a little longer...

    Thank you, I found it, just took a little longer searching.

    Here is the diagram if anyone wants it. It is for '94/95 trucks. I would assume the IGN wires would likely be the same color for '96...
  13. Replies
    7
    Views
    5,262

    Ignition Override & High Idle

    Just wondering if anyone is interested in an ignition override system. Similar to Law Enforcement vehicles where you can push a button and pull the key out with the vehicle still running. The...
  14. Replies
    14
    Views
    5,540

    I second the OPS. Check the output, or try...

    I second the OPS. Check the output, or try energizing the fuel pump before you try to start. You can jump the relay (pins 30 & 87) in the underhood fuse block. If it works make sure you get a...
  15. Thread: No EGR.

    by ZiGBlazer
    Replies
    5
    Views
    3,316

    If mine would have had an EGR I would have sooner...

    If mine would have had an EGR I would have sooner paid the 350 for the 80hp chip to shut it off than replace the dang thing.
  16. Thread: Snow Plows

    by ZiGBlazer
    Replies
    1
    Views
    2,018

    Ok, just in case anyone was wondering, I found...

    Ok, just in case anyone was wondering, I found out more about the Leo plows. Made down in the twin cities, they were made primarily for townships and other municipalities. They are very heavy duty...
  17. Thread: Snow Plows

    by ZiGBlazer
    Replies
    1
    Views
    2,018

    Snow Plows

    I think I finally sold my 6.5l. Partially paid, I still have the truck. It will be missed. It plowed awesome, except for loosing reverse.

    However along with it goes my snow plow. Now I need a...
  18. Replies
    1
    Views
    4,719

    I'm confused

    I have had the truck for sale for a couple months now. Only had one person even take a look at it. I have been cleaning it up so it looks better and it is starting to look pretty good.

    It runs...
  19. Replies
    22
    Views
    13,380

    Very common leak around the back of the engine is...

    Very common leak around the back of the engine is the fuel heater o-ring. Can't help you much about by the tank, there is a return line that could be rusted out.
  20. Replies
    1
    Views
    4,719

    1995 K3500 Ext Cab DRW for Sale

    Got the duals back on, and decided to sell it with the plow for $6500

    http://duluth.craigslist.org/cto/1802183912.html
  21. Replies
    5
    Views
    2,871

    Bottle of water poured over the injection pump...

    Bottle of water poured over the injection pump might give you an idea of the problem. Seems to be happening to a lot of people right now. If it works I think they have been saying the only way to...
  22. Replies
    7
    Views
    2,593

    If I were you I'd put the gauge in in the drain...

    If I were you I'd put the gauge in in the drain hole with a quick drain to make it easy to change the oil if it doesn't hang down too far.

    Otherwise if you want to do it right pull the oil pan...
  23. Thread: 13sec 6.5L

    by ZiGBlazer
    Replies
    4
    Views
    2,337

    Sorry just had to get a laugh in

    Sorry just had to get a laugh in
  24. Thread: 13sec 6.5L

    by ZiGBlazer
    Replies
    4
    Views
    2,337

    I'm fairly certain mine could run better than...

    I'm fairly certain mine could run better than high 31's. I even think a stock truck could.
  25. Replies
    17
    Views
    5,413

    That's what I was getting at with the bottle of...

    That's what I was getting at with the bottle of water. If it cures it then the pump needs to be updated, because it is using old style parts or just wasn't a very high quality build.
Results 1 to 25 of 191
Page 1 of 8 1 2 3 4