SSDieselSupply.com
SSDPro-Exhaust.com

Search:

Type: Posts; User: RipnRun

Page 1 of 15 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    13
    Views
    1,428

    Do the #9 resistors go bad?

    Do the #9 resistors go bad?
  2. Replies
    13
    Views
    1,428

    Thanks. That reminded me, I think I have some...

    Thanks. That reminded me, I think I have some Super Lube dielectric grease in the garage.
  3. Replies
    13
    Views
    1,428

    I have a older pmd that might still be good. I...

    I have a older pmd that might still be good. I replaced it and the 6 foot extension harness before I knew that the harness could be the problem. I'm going to give it a try but I don't have a pink pad...
  4. Replies
    13
    Views
    1,428

    I replaced the Ignition switch a few years back...

    I replaced the Ignition switch a few years back but It has been sticking in the forward position off-and-on over the past 6-8 months.I replaced the 6-foot $25 PMD harness and it still cut off a...
  5. Replies
    13
    Views
    1,428

    It's been running well for the past 5 months,...

    It's been running well for the past 5 months, except for replacing the starter bolts after some past mechanic left off the starter brace. Then last week it cut of twice within a half mile of my...
  6. Replies
    23
    Views
    1,039

    Starting like it should. Thanks again!

    Starting like it should. Thanks again!
  7. Replies
    23
    Views
    1,039

    I had a couple of hours to work on it today....

    I had a couple of hours to work on it today. Thanks to your advice, I was able to disconnect the two wires, remove the starter, and work the broken bolt out. All was done while laying under the...
  8. Replies
    23
    Views
    1,039

    I lost Saturday to installing new gutters out of...

    I lost Saturday to installing new gutters out of town and couldn't work on the truck until this afternoon. The second bracket bolt is 8 x 1.25 20 mm and may need a washer along with the bracket. I...
  9. Replies
    23
    Views
    1,039

    I purchased the bracket and ARP 430-3511 starter...

    I purchased the bracket and ARP 430-3511 starter bolts, If there aren't right I'll return them. I decided to take care of the starter myself, assuming I can work the busted threads out of the block....
  10. Replies
    23
    Views
    1,039

    Thanks very much for the information, Grancito. I...

    Thanks very much for the information, Grancito. I am tempted to take the wheel off and do the starter myself. I wonder what someone else might leave off next time.
  11. Replies
    23
    Views
    1,039

    Thanks for the offer but I found one on Amazon....

    Thanks for the offer but I found one on Amazon. If you don't mind I have a few questions and a couple of pictures.

    I will order a new starter support bracket but the connecting hardware for both...
  12. Replies
    23
    Views
    1,039

    No support bracket.

    No support bracket.
  13. Replies
    23
    Views
    1,039

    Here is a possibly stupid question but remember...

    Here is a possibly stupid question but remember that I'm not a mechanic:

    I looked up the bracket so that I know it's shape but, laying on the ground looking up, where on/near the starter should I...
  14. Replies
    23
    Views
    1,039

    Sorry I have been so long getting back. I twisted...

    Sorry I have been so long getting back. I twisted my back bad and I've been slowly getting caught up on work after being out of commission for a period. I'm ready to replace the block heater and I'm...
  15. Replies
    23
    Views
    1,039

    I do drive on salt roads. I'll give it a shot,...

    I do drive on salt roads. I'll give it a shot, thanks.
  16. Replies
    23
    Views
    1,039

    Thanks, I'll try to get to it from the top.

    Thanks, I'll try to get to it from the top.
  17. Replies
    23
    Views
    1,039

    I couldn't find a visible problem with the block...

    I couldn't find a visible problem with the block heater cord. I couldn't get all the way to the block heater laying on my back in the driveway, lol, but after the first 18 inches the cord is...
  18. Replies
    23
    Views
    1,039

    Thanks, I'll check it out.

    Thanks, I'll check it out.
  19. Replies
    23
    Views
    1,039

    Weird electrical issue?

    I have been plugging my truck into the garage outlet for years with no problems. All of my garage and basement outlets are on one electric circuit, with a GFCI outlet at the beginning of the circuit....
  20. Replies
    0
    Views
    591

    My radio keeps losing electrical power.

    Never mind. Fixed
  21. Replies
    13
    Views
    1,428

    I've never had a problem with the alternator...

    I've never had a problem with the alternator regulator, but I'll keep that in mind, thanks.
  22. Replies
    0
    Views
    274

    Found this 6.5 for sale

    Gone, sold I guess.
  23. Replies
    13
    Views
    1,428

    Thanks for the info. I guess I'll just keep a...

    Thanks for the info. I guess I'll just keep a spare in the truck.
  24. Replies
    13
    Views
    1,428

    Question about replacing the PMD

    Thanks to this forum, I relocated the PMD and heat sink to the bumper hole years ago and, after Grancito told me how to install a manual switch for the fuel pump, I have been driving worry-free for a...
  25. Thread: transmission

    by RipnRun
    Replies
    6
    Views
    1,419

    I am going to change the fluid and filter. When...

    I am going to change the fluid and filter. When the transmission goes, I will check into having it rebuilt, rather that buying a re-manufactured one. Thanks again.
Results 1 to 25 of 353
Page 1 of 15 1 2 3 4